Robility

I created a function to choose a random piece, to move to the left, and to move to the right

I found a driver called FastTinyDriver that is intended for making games on the Attiny85, it uses bitmaps so I created bitmaps for every piece in Tetris in every rotation, and I can rotate them

I rewired the PCB and made the display vertical

After looking over the datasheet for the attiny85, I found out that the down button was set to the reset pin. The first 45 to 50 minutes of this was spent debugging my display, the issue was my power source the entire time, the rest was spent remaking the schematic

The PCB is complete, now I only need to do firmware and a case if I have time

Schematic is complete, now I need to do wiring, firmware, and probably a case.

The PCB is finalized, now I need to do firmware and I forgot to mention in my previous devlogs that I'm gonna make a case as well

After, WAY to much time fumbling around in the PCB editor, I had to change the matrix to be 6x6 instead of 5x5, and I also changed the MCU from a Xiao RP2040 which was really overkill, to an ATtiny85 which is also much cheaper

The schematic is now finished, all that is left is wiring the PCB, and Firmware