Please sign in to access this page

KillerSplit

KillerSplit

8 devlogs
12h 8m
Created by Shaunak Bajaj

NOTE- KICAD Wakatime is very buggy, it dosen't register all the hours. (Onshape is accurate) The PCB hours here is a fraction of what has been put in the project.

An ergonomic, wireless, split, low-profile keyboard. This is a fusion between a Corne and a ZMK Voyager. It has a 6-column layout like the Corne, but the thumb buttons are placed like a Voyager. This is submitted to Grounded YSWS.

Timeline

Ship 1

Shaunak Bajaj

about 1 year ago

Shaunak Bajaj • Covers 8 devlogs and 12h 8m

Finally finished the whole thing. Made a GitHub repo, organised the files. Also made assembly.step which test fits the case, plate and the pcb

Update attachment
Earned sticker

Got an online repository for Corne keyboard ZMK firmware. I forked that and edited the code to add the displays and the pin mapping according to my schematic. The keys are essentially the same between the standard Corne and mine. Link- https://github.com/MrKillerShaunBa/zmk-config-killersplit

Update attachment

Made the right side plate. I know I could mirror the left side but decided against it, just to be sure. I exported edge.cuts and user.eco1 for board and switch outlines. Imported it in Onshape and then built the plate.
Then followed the same steps as before to make the rest of the case.
Took less time than the left side.

Update attachment
Earned sticker

Made the case-
First created the bottom
Then, I made the walls by creating a larger outline
Then extruded and added holes for buttons and charging.

Update attachment

Finally was able to make the plate for my keyboard.

Had tried using ai03's plate generator and used the edge cuts layer to make the plate outline, but the distances between the thumb buttons and their alignment were wrong. It became so frustrating and time-consuming.

Finally exported User.Eco1 layer with the correct 14mmX14mm outline with the keys from KiCAD to make the plate in Onshape.

Update attachment

Made the right side of the keyboard by flipping the left side once and then flipping the individual components again to bring them back to the front. Then wired the PCB and filetted the corners.
Started working on the plate and case for the keyboard.

Update attachment

Changed my mind. Now making the keyhboard using Kailh Choc low profile switches to get a more ergonomic look and function.
Had to change the footprints and then re-wire the entire keyboard and make the board outline again because the choc switches have a different footprint size than the normal MX style switches.

Update attachment

Finalised the idea of the split keyboard I want to make - a crossover between Corne and ZMK Voyager. I want a Corne with Voyager like thumb area.
Made the schematic and routed the left hand side PCB.

Update attachment