picopowered v3

Rerouted the whole thing with some advice from reddit! Also made sure that A7-B7 and A6-B6 connect properly otherwise the USB cable will only work one way (non-reversible). The routing is far cleaner now, especially with the GPIO. The major change is the QSPI flash being rotated so that I don't need to use vias to make it work!

Finally finished the PCB (or atleast enough to post onto reddit). also the sd card thing took way long to make, why does kicad footprint editor suck :(. Also ditched the edge connector, and added a DIP switch.

I did a lot of routing and rerouting the PCB smh, it is very hard to get it right in the first try. The PCB looks clean now, and i just need to make the custom SD card footprint. Idk where to put it tho cuz it has some NTPH holes and it'll collide but i want it on the back side. I might move the USB C port further down and add the SD card in the new space and a silkscreen on the other side. I wanna get this in black + ENIG so this should look awesome ✌️🥰🥰

Took some while but i finally finished the Schematic for the board. Also decided to add an SD card slot on the back but I'll figure out how to solder all that later on.

started to work on the schematic! Tiling everything up so it looks better in kicanvas and the PDF later on :)